Polyvance 6225 2-Part Tab Magic Molding Putty (100 g)
Tab magic molding putty is a two-part moldable, flexible silicone rubber which is non-toxic and temperature resistant. Mix equal parts until a uniform green color is achieved, then quickly press onto the headlight tab where it needs to be welded. The rubber will cure in about 15 minutes and tightly support the fine details on the top of the headlight tab while you weld the backside with your Polyvance nitrogen plastic welder. When finished, peel off the flexible Tab Magic putty to reveal a nearly-finished tab that should just need minor work to finish. Although Tab Magic Molding Putty is not remoldable, it is reusable on the same type of headlight tab. Many headlight tabs have complex features that are very difficult to restore. If the headlight tab is visible to the vehicle owner, it must be repaired and refinished to the original appearance. 6225 Tab Magic Molding Putty from Polyvance helps ease the refinish of these complex tabs by preventing the backside weld from blowing through and creating imperfections that would be difficult to refinish. 6225 Tab Magic Molding Putty is a two-part moldable, flexible silicone rubber which is non-toxic and temperature resistant. Mix equal parts until a uniform green color is achieved, then quickly press onto the headlight tab.
Features:
- 2-Part Silicone Putty makes a "negative" of the broken tab.|5 minute working time gives you plenty of time to make the mold.|Fully cures in about 20 minutes.|Prevents backside weld from blowing through.|Restore headlight tabs to pre-accident condition.
No SDS/TDS file available at this time.